The conductometer is designed to measure specific electrical conductivity (SEC) of acids,
alkalis, salts solutions and others, which do not form a film on the sensor electrodes.
The conductometer is equipped with a conductivity sensor with platinized electrodes and an
integrated temperature sensor, power supply unit and a tripod.
Scope of application: factory and workshop laboratories at the enterprises of heat
and power industry, chemical, petrochemical, pulp and paper, food processing, dairy,
brewing and other industries.
Conductometer provides digital display of the measured parameters values and data exchange via digital interface
RS-232 or RS-485, as well as archiving and graphical display of measurements results.
automatic selection of one of four measuring ranges;
temperature compensation mode selection, automatic or manual;
simplified calibration with one solution.
SEC measuring range:
from 0,00 μS/cm to 20,00 mS/cm (changing the position of the comma and switching the units of measurement is automatic)
Basic absolute accurancy when measuring SEC at a measurement temperature (20 ± 5)°C
±(0.01 x A) where A is the conductivity readings.
Operating temperature range
Basic absolute accurancy in temperature deviation
max ± 0,5 °C
Reference temperature for termocompensation 1)
according to the order (default +25°C)
Thermocompensation range relatively the reference temperature
Pressure of the analyzed fluid (at a temperature of the analyzed fluid of 25 ºС)
Sensor cable length
Type of display
interface RS-232 and RS-485 protocol ModBus RTU
The capacity of the archive (the number of records of pairs of values
of the main measured parameter (SEC) and temperature)
programmable from 1 sec to 5 min
from 4.4 hours to 55 days
Dust and water protection MI enclosures
IP54 (front panel)
Resistance to mechanical influences in accordance with GOST R 52931 (Rus)
max 15 VA
max 1 kg
1) The reference temperature of termocompencation (°C) and the temperature coefficient (% per °C) are set